MS20664 Ball End, Wire Rope, Swaging, Single Shank

Pages 1 - 2 - 3 - 4

MS20664G

*                                                   EXAMPLE:     MS 20664 C 2

Dash number

Use "C" for CRES Specification sheet number

MS prefix

2.  Dimensions are in inches.

*                           3.  Remove burrs and sharp edges.  (See MIL-DTL-781.)

4.  Interpret drawing in accordance with ASME Y14.5M.

5.  In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence.

6.  Unless otherwise specified, issues of referenced documents are those in effect at the time of solicitation.

7.  MS20664 and AN664 parts identified by the same dash numbers are universally, functionally and dimensionally interchangeable.

8.  Corrosion resistant steel parts shall be used for new design and can be universally substituted for carbon and alloy steel parts as shown in table II.  Carbon and alloy steel parts cannot be substituted for corrosion resistant steel parts.

9.  Carbon and alloy steel parts are inactive for new design.

TABLE II.  Substitution table.

3