MS20667K
NOTES:
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
1. The part or identifying number (PIN) to be used for terminals acquired to this specification is created as shown below.
EXAMPLE: MS 20667 - 6
Dash number (see table I)
Specification sheet number
MS prefix
2. Dimensions are in inches.
3. Interpret drawing in accordance with ASME Y14.5M.
4. Remove burrs and sharp edges. (See MIL-DTL-781.)
5. Interchangeability relationship: MS20667 and AN667 parts identified by the same dash number are universally, functionally, and dimensionally interchangeable.
6. In the event of a conflict between the test of this document and the references cited herein, the text of this document takes precedence.
7. Unless otherwise specified, issues of referenced documents are those in effect at the time of solicitation.
8. MS20667 supersedes AN667.
9. Corrosion resistant steel parts can be universally substituted for carbon and alloy steel parts in accordance with table II. Carbon and alloy steel parts are inactive for new design and cannot be substituted for corrosion resistant steel parts.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business