MS21251M
4. Interpret drawing in accordance with ASME Y14.5M.
5. For clip locking of turnbuckles, see MS33736 and MIL-DTL-8878.
6. For 0.125 (1/8) inch diameter wire rope use -5 parts, minimum breaking strength
2,200 pounds (lbs.) (reference).
7. A turnbuckle with a manufacturing date of 1978 or older shall not be used for replacement repairs since stress relieving was not required prior to this date.
8. In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence.
9. Unless otherwise specified, issues of referenced documents are those in effect at the time of solicitation.
CHANGES FROM PREVIOUS ISSUE: The margins of this specification sheet are marked with asterisks to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to
the previous issue.
Custodians: Army - AV Navy - AS
Air Force - 99
Preparing Activity: DLA - GS5
(Project 1560-0019)
Review Activities: Navy - MC
Air Force - 71
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business