MS21253S
NOTES:
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
1. The part or identifying number (PIN) consists of the letters MS, the specification sheet number, and a dash number taken from table I. A "C" in lieu of dash indicates 17-4PH; a dash indicates carbon or alloy steel. The first letter following the dash number or letter C indicates direction of thread (left or right hand) and the second letter indicates length (short or long).
EXAMPLE: MS 21253 - 3RL
Dash number (see table I) Use "C" for 17-4PH
or a dash for carbon or alloy steel
Specification sheet number
MS prefix
MS21253C3LS Indicates - Clevis end, 17-4PH, 0.1900 (#10)-32 left hand thread, short. MS21253-3RL Indicates - Clevis end, steel, 0.1900 (#10)-32 right hand thread, long.
2. Remove burrs and sharp edges. (See MIL-DTL-8878.)
3. Dimensions are in inches.
4. Interpret drawing in accordance with ASME Y14.5M.
5. In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence.
6. Unless otherwise specified, issues of referenced documents are those in effect at the time of solicitation.
7. For clip locking of turnbuckles, see MS33736 and MIL-DTL-8878.
8. Cutter radius mark, which is used as a clip slot alignment indicator, must be present on this surface.
9. Cutter radius marks are permitted on this surface and shall not be cause for rejection.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business