MS21256G
TABLE I. Dash numbers and dimensions.
*
*
1/ Dimension A must be held without distortion at end.
REQUIREMENTS:
1. Dimensions: Dimensions are prior to coating and in inches.
2. Tolerances: Unless otherwise specified, tolerances: decimals ± 0.015; all internal radii are 0.032 +0.000/-0.015.
3. Material: Corrosion resistant steel wire shall be in accordance with MIL-DTL-8878.
4. Marking: Marking shall be in accordance with MIL-DTL-8878.
5. Ends: Ends of locking clip shall be cut square and shall be free of burrs. NOTES:
1. The part or identifying number (PIN) consists of the letters MS, the specification sheet number, and a dash number taken from table I.
EXAMPLE: MS 21256 - 1
Dash number
Specification sheet number
MS prefix
MS21256-1 Indicates - Clip, turnbuckle, 0.965 long.
2. Locking clips are for one time use only and shall not be reused or altered. For lock clipping of aircraft turnbuckles, see MS33736 and MIL-DTL-8878.
3. Stock manufactured to the previous revision shall be acceptable for 24 months after the date of this revision.
4. In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business