MS21259 Terminal, Wire Rope, Swaging, Stud, Long Thread

Pages 1 - 2 - 3 - 4 - 5

MS21259K

2.  Dimensions are in inches.

3.  Remove burrs and sharp edges.  (See MIL-DTL-781.)

4.  Interpret drawing in accordance with ASME Y14.5M.

5.  These terminals are not to be used with turnbuckle bodies (barrels).

6.  In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence.

7.  Unless otherwise specified, issues of reference documents are those in effect at the time of solicitation.

8.  Interchangeability relationship:  MS21259 parts can universally replace the canceled AN666 parts identified by the same dash number; but the canceled AN666 parts cannot replace the superseding MS21259 parts.  MS21259 corrosion resistant steel parts can universally replace the canceled carbon and alloy steel parts identified by the same dash number.

9.  Carbon and alloy steel parts are inactive for new design.

10.  Marking:  Complete MS part number, indented.  Use two faces if required.  For terminal sizes -2 through -5, use basic part number only, example, MS21259.

CHANGES FROM PREVIOUS ISSUE:  The margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made.  This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations.  Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue.

NOTE:  The activities listed above were interested in this document as of the date of this document.  Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST database at https://assist.daps.dla.mil/.

5