INCH-POUND
MIL-DTL-6117L
13 August 2008
SUPERSEDING
MIL-DTL-6117K
22 December 2005
DETAIL SPECIFICATION
WIRE ROPE ASSEMBLIES, AVIATION, SWAGED TYPE
This specification is approved for use by all Departments and Agencies of the
Department of Defense.
1. SCOPE
1.1 Scope. This specification covers swaging terminals to wire rope to fabricate wire
rope assemblies. It also provides the requirements, criteria, and provisions for qualification of
wire rope assembly manufacturers for listing in a Qualified Manufacturers List (QML).
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this
specification. This section does not include documents cited in other sections of this
specification or recommended for additional information or as examples. While every effort has
been made to ensure the completeness of this list, document users are cautioned that they must
meet all specified requirements of the documents cited in sections 3 and 4 of this specification,
whether or not they are listed.
2.2 Government documents.
2.2.1 Specifications. The following specifications form a part of this document to the
extent specified herein. Unless otherwise specified, the issues of these documents are those cited
in the solicitation or contract.
Comments, suggestions, or questions on this document should be addressed to Defense Supply
Center Richmond, ATTN: DSCR-VEB, 8000 Jefferson Davis Highway, Richmond, VA 23297-
5616 or emailed to STDZNMGT@dla.mil. Since contact information can change, you may want
to verify the currency of this address information using the ASSIST database at
https://assist.daps.dla.mil/.
AMSC N/A
FSC 1640
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business